[Top] [All Lists]

Re: [TenTec] New and Improved Terminology (NVIS origins)

To: "'Discussion of Ten-Tec Equipment'" <tentec@contesting.com>
Subject: Re: [TenTec] New and Improved Terminology (NVIS origins)
From: "Rick - NJ0IP / DJ0IP" <Rick@DJ0IP.de>
Reply-to: Discussion of Ten-Tec Equipment <tentec@contesting.com>
Date: Wed, 5 Jan 2011 17:53:44 -0500
List-post: <tentec@contesting.com">mailto:tentec@contesting.com>

Jim puts forth good arguments, but it goes against what I have learned many
years ago.
Your thoughts please.


-----Original Message-----
From: tentec-bounces@contesting.com [mailto:tentec-bounces@contesting.com]
On Behalf Of Richards
Sent: Wednesday, January 05, 2011 4:45 PM
To: Discussion of Ten-Tec Equipment
Subject: Re: [TenTec] New and Improved Terminology (NVIS origins)

Er... ah...   No joke.   Do you doubt the proposition that a
good ground plane lowers radiation take off angle?  If so,
I would be curious as to your reasons.   (Seriously, and with
no intention to flame or cause an argument, as I have
made quite an investment in time and resources in vertical
developing a reasonably decent vertical antenna system
for my small, suburban back yard.   Any info would be
greatly appreciated. )

FYI ---

------ Extra Class Exam Questions of interest -----

Question E9A12  - and the answer is that the efficiency
of a quarter wave grounded vertical antenna can be improved by
installing a good radial system.

Question E9A13 - answer is - soil conductivity is the most important
factor in determining ground losses for a ground-mounted vertical
antenna operating in the 3-30 MHz range.

Question E9C13 - answer is - When a vertically polarized antenna
is mounted over seawater versus rocky ground, the far-field
elevation pattern low-angle radiation increases.

Question E9C17 - answer - The main effect of placing a vertical
antenna over an imperfect ground is that it reduces low-angle

Also, on the audio study guide, Gordo makes some stray comments
about using 3 inch copper strap for radials on his roof, and
mentions improving the ground field increases low angle
radiation  - he goes on to say it does not increase signal strength,
of course, but only that it increases the amount of signal that
has low take off angle.

This information is consistent with all that I have read on verticals
in the ARRL Antenna Handbook, and I did LOTS of research before
installing a large vertical monopole in the back yard.

A huge ground pane does lower take off angle (as NEC modeling
shows) and also improves antenna efficiency -- I stopped at 65 radials
but I wish had installed even more just to be sure.    Also, my back yard
soil is very conductive and remains moist even through the summer, so
the soil, itself, helps me considerably.   Rob Sherwood and I exchanged
some nice email at the time I was doing this homework, and I believe
he lives over a more dry, rocky soil, and that is much harder to work
over.   I also corresponded with the infamous  Rudy Severns N6LF
and his findings are consistent with this conclusion.    NEC modeling
produces consistent results.

N'est ce pas?       Happy trails OM.

===============  JHR  ============================

I had

On 1/5/2011 1:01 PM, Steve Hunt wrote:
> I presume the "wink" indicates that is a joke !
> The only thing that would improve the elevation pattern would be
> improved ground conditions in the Fresnel Zone where the ground
> reflections are taking place. That would take some awfully long radials
> - certainly well beyond my property boundary - and an awful lot of them
> to achieve a copper density that would affect the conductivity so far out.
> 73,
> Steve G3TXQ

TenTec mailing list

TenTec mailing list

<Prev in Thread] Current Thread [Next in Thread>