A power transistor failed after 5-6 years of use and Heinz did a great job
of troubleshooting and repair. There was a parts shortage at time of mfr
and factory made a slightly inelegant substitution. No big deal. That's
how I read it.
73, Barry N1EU
On Wed, Jan 12, 2011 at 10:57 PM, <email@example.com> wrote:
> I would call Paul Clinton TT service mgr and ak about this..or complain
> about this????
> That shoud not happen. I wander how many tey had go out that way>???
> Lee, KC9CDT
> -----Original Message-----
> From: Heinz Dietmar Karl <firstname.lastname@example.org>
> To: tentec <email@example.com>
> Sent: Wed, Jan 12, 2011 4:48 pm
> Subject: [TenTec] Orion Display and Power Distribution Board
> Hallo Orion users,
> 2 weeks ago I`ve got an Orion1. It was announced to be full ok.
> But as I switched it on , I saw the display was a little dark in the
> upper left corner
> and was flickering during transmission.
> After a discussion with the former owner i was looking for the reason.
> After studying the schematics and some measurements I found the reason .
> The +5volts- voltage on the power distribution board A9 is unstable.
> During transmission and by changing the power voltage e.g. the
> 5V-voltage alternates between 5 and 4,4 volts.
> At first I tried to get an new board . But it was not on stock at Ten
> Then I found this forum here and could learn what has happend before
> with some failures around the unstable 5 volts.
> But changing the recommended board-capacitors brought no better
> Then I saw a difference between the board schematic and the circuitry
> my A9 board:
> On my board the upper PNP -transistor was not the original type TO220P
> NTE 378.
> Ten Tec had used -how long?- another type BD246C .
> Because this one is a TO3P Type and not fittable onto the bord , it was
> mounted very carefully-like production people do it-
> via 8cm long wires beside the A9 board on the al -case.
> I am very sure this outsourced transistor has worked in my Orion since
> it has left the production.
> ( Serial Nr. 10C 10584 in 2005)
> I ordered- over night- the the original NTE 378 from a semiconductor
> dristributor, placed it next morning
> within 15 minutes directly onto the board and it worked perfectly.
> see http://www.qrz.com/db/DJ8LX
> The +5volts are stable under all conditions .
> Now I am very happy with my Orion.
> best 73
> Heinz , DJ8LX
> TenTec mailing list
> TenTec mailing list
TenTec mailing list