TenTec
[Top] [All Lists]

Re: [TenTec] 715

To: Discussion of Ten-Tec Equipment <tentec@contesting.com>
Subject: Re: [TenTec] 715
From: Billy Cox <aa4nu@ix.netcom.com>
Reply-to: Billy Cox <aa4nu@ix.netcom.com>, Discussion of Ten-Tec Equipment <tentec@contesting.com>
Date: Fri, 4 Mar 2011 23:02:10 -0600 (GMT-06:00)
List-post: <tentec@contesting.com">mailto:tentec@contesting.com>
That's a good idea to try, another one would be to
leave the mic/715/cable to rig inline and disconnect
the power supply line ... see if anything changes?

That might help to isolate the actual RF entry point.

Hope that helps!

73 de Billy, AA4NU


-----Original Message-----
>From: Richards <jruing@ameritech.net>
>Sent: Mar 4, 2011 10:25 PM
>What happens if you coil the cable that runs between the715 and the 
>radio?    Similarly if you introduce a coil in the mic cable to the 715? 
>  Any help if you do this?
>
>Happy Trails.
>=======================  Richards / K8JHR  =========================
>
>On 3/4/2011 10:16 PM, ROD wrote:
>> I just received a ten tec 715 rf speech processor and I have rf for the 
>> first time at my station .It is there when I have it hooked to my orion does 
>> not matter if it isin or out I remove the mike from the 715 and hook it up 
>> to my orion no rf. any one else had trouble. 73 ROD

_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec

<Prev in Thread] Current Thread [Next in Thread>