Thanks, Ray. That did it! I never would have thought of that on my own.
On 03/20/2011 01:57 PM, Rsoifer@aol.com wrote:
> Hi John,
> I just did some experimenting. I generally use UCW, but for this test I
> set the O2 to LCW and turned it on. It came up at 2400 Hz. I then set BW
> to 500 Hz, turned off the radio, and turned it back on. 2400 Hz. Then, I
> set it to 500 Hz again and cycled the band button through its 4 stack
> memories. Success! After turning the rig off and on, it now comes up at
> 500 Hz.
> 73 Ray W2RS
> In a message dated 3/20/2011 5:45:02 P.M. GMT Standard Time, firstname.lastname@example.org
> On 03/20/2011 12:48 PM, pfizenmayer wrote:
>> By any chance do you have the RX>BW track or RX>PBT track turned on ?
>> might be doing it .
>> Hank K7HP
>> ----- Original Message -----
>> From: "John K3GHH" <email@example.com>
>> To: <TenTec@contesting.com>
>> Sent: Sunday, March 20, 2011 5:10 AM
>> Subject: [TenTec] Default LCW BW 1000Hz
>>> After a recent update of O2 firmware to 2.044A, when I first turn the
>>> rig on its bandwidth (on LCW mode) is 1000 Hz. When I turn the rig off
>>> the bandwidth is usually 500 Hz and often less --- certainly never
>>> anything near as wide as 1000. How do I change this boot-up default
>>> John K3GHH
>>> TenTec mailing list
>> TenTec mailing list
> Thanks, Hank... but they're both off.
TenTec mailing list