[Top] [All Lists]

Re: [TenTec] Fw: Omni C transmit off frequency

To: Discussion of Ten-Tec Equipment <tentec@contesting.com>
Subject: Re: [TenTec] Fw: Omni C transmit off frequency
From: Richards <jruing@ameritech.net>
Reply-to: Discussion of Ten-Tec Equipment <tentec@contesting.com>
Date: Tue, 22 Mar 2011 23:53:56 -0400
List-post: <tentec@contesting.com">mailto:tentec@contesting.com>
Say.... fellas...

I hope I am not out of step here, but my very good ham friend, Chuck, 
AJ8W, is working on what sounds like a very similar adjustment to his 
Omni-C, so I sent a copy of your exchange to him.

He replied as follows:

                Let him know that the sideband freq is correct and
                that CW will be off freq. as stated in the manual but
                the 750 hz of off set. It sends CW 750 off the receive
                freq. you hear. Don't remember the page but in the
                front of the manual and at the bottom of a page.
                Just wait I'll look. It's is on page 2-9 under Operating
                Hints item 8.

I don't know if this helps, but I am passing it along just in case it is
helpful in some way.

If not, I apologize for wasting bandwidth, my road to Hell is well
paved with my good intentions.   ;-)

Happy Trails.
=======================  Richards / K8JHR  =========================

On 3/22/2011 1:07 PM, Curt wrote:
> Yes, thanks Mike.  I had found R-16 after your first message, of course I
> violated rule #1, RTFM.
TenTec mailing list

<Prev in Thread] Current Thread [Next in Thread>