[Top] [All Lists]

[TenTec] Omni C crystal holder source

To: "Discussion of Ten-Tec Equipment" <tentec@contesting.com>
Subject: [TenTec] Omni C crystal holder source
From: "Hulett, Russell" <rhulett1@consolidated.net>
Reply-to: Discussion of Ten-Tec Equipment <tentec@contesting.com>
Date: Wed, 23 Mar 2011 08:22:29 -0400 (EDT)
List-post: <tentec@contesting.com">mailto:tentec@contesting.com>
The Omni C is working ok after adjustments.  I even managed to get 30 and 10M 
working by wedging wire into the loose crystal sockets.  

I asked Ten-Tec whether they still stocked the crystal holders for the Omni 
series, of course the answer was "no".  So, has anyone found a useful 
substitute to warrant difficulty of removing the oscillator board to permit 
replacing the sockets?  Anyone replaced the sockets?  I'd like to repair the 
board properly, the existing crystal holder is in pretty poor condition.

73, Curt KB5JO
TenTec mailing list

<Prev in Thread] Current Thread [Next in Thread>