TenTec
[Top] [All Lists]

Re: [TenTec] Hercules II 9420 Power Supply Problem

To: Discussion of Ten-Tec Equipment <tentec@contesting.com>
Subject: Re: [TenTec] Hercules II 9420 Power Supply Problem
From: d.e.warnick@comcast.net
Reply-to: Discussion of Ten-Tec Equipment <tentec@contesting.com>
Date: Mon, 16 May 2011 14:34:26 +0000 (UTC)
List-post: <tentec@contesting.com">mailto:tentec@contesting.com>

OK, let's try this again. 

First, there was no intent to offend or to give a smart a**ed answer. 

No I do not have resonant antennas. Only a 160M dipole in the trees tuned to 
all bands with a Palstar BT1500A tuner. Yes, I have had RF problems. 



Now, back to the 9420 PS. The load sensing for turn-on of the supply when only 
the transceiver is used (no, I never powered my rig from the 9420 either) is 
around transistor Q1. However, Q1 provides a signal to the same Q7 that 
normally turns on the power supply. Removal of Q1 should defeat this circuit. 
The problem here is that the RF may still affect the supply turn-on circuitry 
outside the load sensor. That and that alone is why I suggested dealing with 
the 'RF problem' 



No, a poor answer will not derail the guys on this reflector from offering an 
alternative answer. 



Again, no offense intended. There's very little or none of that on this 
reflector. Only an attempt to help. Sorry I didn't fix it for you the way you 
wanted 



Dave 

WA3F 


----- Original Message ----- 
From: "John Huffman" <hjohnc@gmail.com> 
To: "Discussion of Ten-Tec Equipment" <tentec@contesting.com> 
Sent: Sunday, May 15, 2011 3:43:01 PM 
Subject: [TenTec] Hercules II 9420 Power Supply Problem 

I use the Ten Tec 9420 power supply with my Hercules II.  It has the 
following problem - 

With the Herc turned off, there are times when RF in the shack on 
certain band and antenna combinations causes the power supply to turn on 
and off in time with CW keying.  A big thump and buzz on each dit and dah. 

With the amp turned on this is not a problem, the power supply just 
stays on. 

I don't use the transceiver output from the power supply and only use it 
to run the Herc. 

I suspect the transceiver sensing circuit is sensing a load in these 
situations and turning the supply on.  How can I disable that "feature"?? 

73 de K1ESE 
John 
_______________________________________________ 
TenTec mailing list 
TenTec@contesting.com 
http://lists.contesting.com/mailman/listinfo/tentec 
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
<Prev in Thread] Current Thread [Next in Thread>