Oh, yeah. Slips right OFF. ON, well that's a different story. I've rebuilt 15
or 20 PTO's among Corsairs and Omni D's. Finally made a metal tool to hold that
little spring. There's a whole chapter of bad words for that operation. Not at
all impossible, just a challenge
Dave
WA3F
----- Original Message -----
From: "Jerry Haigwood" <jerry@w5jh.net>
To: "Discussion of Ten-Tec Equipment" <tentec@contesting.com>
Sent: Friday, October 21, 2011 10:58:11 AM
Subject: Re: [TenTec] How do you remove the Corsair II Tuning Knob?
I think I'll pass on the exclusive club! Does the dial skirt just
slip/slide off?
Jerry W5JH
-----Original Message-----
From: tentec-bounces@contesting.com [mailto:tentec-bounces@contesting.com]
On Behalf Of Steve Hunt
Sent: Friday, October 21, 2011 9:47 AM
To: Discussion of Ten-Tec Equipment
Subject: Re: [TenTec] How do you remove the Corsair II Tuning Knob?
Jerry,
"Am I now in the exclusive club? ;-) "
Not until you've drilled out the set-screw hole and re-tapped it for
something bigger. And not until you can replace the dial skirt without
using bad words :)
73,
Steve G3TXQ
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|