| To: | "tentec@contesting.com" <tentec@contesting.com> |
|---|---|
| Subject: | [TenTec] trouble interfacing OMNI VI to N1MM via serial port |
| From: | Joseph Holstein <n8ea@prodigy.net> |
| Reply-to: | Joseph Holstein <n8ea@prodigy.net>, Discussion of Ten-Tec Equipment <tentec@contesting.com> |
| Date: | Thu, 17 Nov 2011 09:36:14 -0800 (PST) |
| List-post: | <tentec@contesting.com">mailto:tentec@contesting.com> |
followed instructions in the TenTec manual and have pins 2 and 3 and 7 on the DB 25 going to the DB 9 . DB 9 has pins 4 and 6 shorted. Followed directions in N1MM for Omni VI - 1200 baud etc. Pin 5 on DB9 connects to pin 7 on the DB25. Any suggestions ? 73 joe n8ea _______________________________________________ TenTec mailing list TenTec@contesting.com http://lists.contesting.com/mailman/listinfo/tentec |
| <Prev in Thread] | Current Thread | [Next in Thread> |
|---|---|---|
| ||
| Previous by Date: | Re: [TenTec] Original Message, Richards |
|---|---|
| Next by Date: | Re: [TenTec] trouble interfacing OMNI VI to N1MM via serial port, Ed |
| Previous by Thread: | [TenTec] Original Message, Will Harper |
| Next by Thread: | Re: [TenTec] trouble interfacing OMNI VI to N1MM via serial port, Ed |
| Indexes: | [Date] [Thread] [Top] [All Lists] |