TenTec
[Top] [All Lists]

Re: [TenTec] Omni VI + Interconnect Schematic

To: Discussion of Ten-Tec Equipment <tentec@contesting.com>
Subject: Re: [TenTec] Omni VI + Interconnect Schematic
From: Barry N1EU <barry.n1eu@gmail.com>
Reply-to: Discussion of Ten-Tec Equipment <tentec@contesting.com>
Date: Sat, 10 Dec 2011 17:55:32 +0000
List-post: <tentec@contesting.com">mailto:tentec@contesting.com>
There is no interconnect drawing in either the 563 or 564 manuals.

73, Barry N1EU

On Sat, Dec 10, 2011 at 5:46 PM, Clayton Brantley
<clayton_n4ev@yahoo.com> wrote:
> Wayne:  I have an Omni VI rev 3 and I'm sure there is a drawing the the 563 
> manual.  I'll look a bit later
> today for you.
>
> I did a quick check on the 564 book that I downloaded and you're right!  It's 
> missing!
>
> 73 Clayton N4EV
>
>
>
> ________________________________
>  From: n2wk <n2wk@rochester.rr.com>
> To: tentec@contesting.com
> Sent: Saturday, December 10, 2011 12:03 PM
> Subject: [TenTec] Omni VI + Interconnect Schematic
>
> Is there a drawing (schematic)for the Omni VI+ showing all of the 
> interconnect boards available?
> I do not have one in my Omni VI Plus manual. This would be a large Drawing 
> showing the entire layout of the connections from board to board. I could use 
> one. Anybody Please.
>
> 73, Wayne N2WK
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
<Prev in Thread] Current Thread [Next in Thread>