TenTec
[Top] [All Lists]

Re: [TenTec] Re. [Ten Tec] Grounds How to Bond?

To: Discussion of Ten-Tec Equipment <tentec@contesting.com>
Subject: Re: [TenTec] Re. [Ten Tec] Grounds How to Bond?
From: Stuart Rohre <rohre@arlut.utexas.edu>
Reply-to: Discussion of Ten-Tec Equipment <tentec@contesting.com>
Date: Tue, 24 Jan 2012 16:55:30 -0600
List-post: <tentec@contesting.com">mailto:tentec@contesting.com>
We do use bolted and clamp connections in bonding our flat straps to our 
bus strap.  Carefully cleaned and even using some no oxidizing compound 
or other protection from corrosion.

The posted answer about bonding was a good general definition.
You can also find rods thermally bonded to ground conductors by other 
than mechanical clamping.  This is done by Thermite welding, where metal 
is melted at the bond.

Stuart Rohre
K5KVH
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec

<Prev in Thread] Current Thread [Next in Thread>