[Top] [All Lists]

Re: [TenTec] RX366, v3 firmware

To: Discussion of Ten-Tec Equipment <tentec@contesting.com>
Subject: Re: [TenTec] RX366, v3 firmware
From: amsctalx@comcast.net
Reply-to: Discussion of Ten-Tec Equipment <tentec@contesting.com>
Date: Mon, 30 Jan 2012 18:36:44 +0000 (UTC)
List-post: <tentec@contesting.com">mailto:tentec@contesting.com>
John - 

I would like to connect a panadapter to my O2, and this is shaping up as a 
better way than the current "improvisations" (buffer amps connected to SMD 
components, etc.). I would like, though, to be able to switch the 
below-mentioned IF output between receivers and, assuming that isn't possible, 
connect the output to the main RX. Will there be a provision made for this 
capability in a potential factory-installed upgrade package? 


Mike Alexander - N8MSA 


----- Original Message -----
From: "John Henry" <jhenry@tentec.com> 
To: "Discussion of Ten-Tec Equipment" <tentec@contesting.com> 
Sent: Monday, January 30, 2012 1:16:21 PM 
Subject: [TenTec] RX366, v3 firmware 

Hi Pat, 

The RX366 is a replacement for the existing sub-rx, giving more 
features/functions/better receiver specs, making the main and sub at the 
same performance level now. Along with a built in sub-rx preamp and 
attenuator and slots for 3 roofing filters for the sub-rx. 

Whereas it doesn't provide line level outputs for listening or computer 
interfacing, it does have a 9MHz IF output connector on it in case someone 
wanted to run a panadapter from their sub-receiver. 

John Henry 

On Mon, Jan 30, 2012 at 5:10 PM, Pat Patterson <ppattrsn at swbell.net 
<http://lists.contesting.com/mailman/listinfo/tentec>> wrote: 
>* Barry,*>* With the RX366 update to the OII is it possible to get 
>simultaneous line level*>* output from both the Main and Sub RX? The 
>connectors are there on the OII but*>* the internal audio path isn't 
>complete.*>* Thanks,*>* Pat, W5VY* 
TenTec mailing list 
TenTec mailing list

<Prev in Thread] Current Thread [Next in Thread>