If the sub receiver was always on the Beverages, then it is no wonder that
no one complained.
The old sub receiver did not have a problem with sensitivity or selectivity.
It's problem was, it would overload with too much signal, especially a
strong adjacent channel signal.
The signal levels that a Beverage delivers is a lot lower than that of a
normal dipole or vertical.
Besides, the second receiver in the Orion was not "that" bad to begin with.
Without looking it up, I'll just speculate and say it is probably as good or
better than the FT-1000's RX, unless the 1000 has an Inrad filter.
From: email@example.com [mailto:firstname.lastname@example.org]
On Behalf Of Richards
Sent: Tuesday, January 31, 2012 3:03 AM
To: Discussion of Ten-Tec Equipment
Subject: Re: [TenTec] RX366
My friends worked the CQ WW 160m DX contest on an Orion II with a dopey
old sub-receiver, working it in stereo with the main receiver, and no
one complained about it. One receiver was on a huge tower loaded as a
vertical transmit-receive antenna and the sub-receiver was on a pair of
phased array steerable Beverage antennas, and the guys all thought it
was DA BOMB (... some of these guys are K3 owners...)
Parenthetically, the other rigs on the station desk, were a TT Omni VII
and TT Omni VI Plus ... we sometimes used Omni VII as a second receiver
-- and, again, no one complained about that, either. They were using a
TT Titan amp that ran quiet and hardly got warm. The boys in
Sevierville would have been proud.
The radios are mixed and controlled with a MicroHAM MK2R+ SO2R
controller that is both hardware and computer savvy. Man what a setup.
Totally instant and automatic control of both rigs, with one key and
one set of phones, and integration with the logging software - expensive
but very cool.
So... while the Orion II sub-receiver will be getting better... no one
complained about the old one this past weekend.
Just My take... Some of the guys asked me what I have at home, and I
had fun saying I have an Omni VII and Centurion with model 715 processor.
Carl N4PY would have been proud as I explained how he set up his
software so I can use a TT RX-320D as a second receiver and ersatz
panadapter to tune with a mouse to a continuously updating band scope
spectrum display without having to buy a $700 panadapter.
==================== JHR ==========================
On 1/30/2012 1:12 PM, Jim Noe wrote:
> I am fairly new subscriber. Have seen postings about the RX366 - recent
and some older ones.
> The complaint I hear of the OII is that it has only one good receiver.
> Does the RX366 when installed then make the second receiver equal to the
> Jim K6AR
> TenTec mailing list
TenTec mailing list
TenTec mailing list