Tnx Carter for the info. Yes, as I mentioned in my question, I remember some
fixes also from TT.
Can't find them though.
> On 1/31/2012 5:06 PM, Stuart Rohre wrote:
> > Try coiling up part of a mike cable into an orderly solenoid coil,
> > NOT scramble wound. You can put it on a pop bottle or other pipe
> > form for a test. If that works, you can measure and compute what
> > inductance it was and replicate it with a ferrite core, passing the
> > mike cable thru and around that for fewer turns.
> > If you want to get deep into the radio, see if there are ferrite
> > beads on the mike connector wiring, and if not, add that. Beads web
> > sites usually have application notes on how much equivalent
> > inductance you get per bead and you can put multiple beads if there
> > is room. Insulate the beads from contact with chassis or other
> > conductors.
> This may or may not be the time/place to bring this up, but here goes
> I've got an Omni VI Option 3 and could never run more than ~ 15 watts
> without RF getting in to the transmit audio. Tried the above with a
> ferrite core and no luck. After years of avoiding SSB, there was finally
> talk here on the reflector about the cause of the problem, ultimately
> named the "pin 1" problem. (Had something to do with pin 1 on the mic
> connector and a floating ground or some such between the connector and
> the PC board).
> I called TT tech support and they sent me a sheet with the suggested
> fix. However, being a CW and digital op, I never worked on the problem.
> Several years later, when I had need to get on SSB, I could not find the
> sheet TT sent to me. When I called them to get a new sheet, they
> disavowed any and all knowledge of the issue.
> So, what is happening here? Am I totally hallucinating? Am I missing
> something? Does anyone here on the reflector remember the "pin 1"
> thread? BTW, TT says too much RF in the shack -- but I've had other
> solid state rigs (Drake TR-7) work fine; also, because of the physical
> layout of the house/property/trees and zoning and subdivision
> restrictions, I am not able to re-locate my antenna as suggested by TT.
> Any fixes -- or is this just an inherent issue with the Omni VI?
> Any thoughts or comments appreciated...
> Carter K8VT
> TenTec mailing list
TenTec mailing list