[Top] [All Lists]

[TenTec] Orion II Firmware V3.026

To: tentec@contesting.com
Subject: [TenTec] Orion II Firmware V3.026
From: Barry LaZar <k3ndm@comcast.net>
Reply-to: Discussion of Ten-Tec Equipment <tentec@contesting.com>
Date: Thu, 02 Feb 2012 16:03:46 -0500
List-post: <tentec@contesting.com">mailto:tentec@contesting.com>
Loaded it this afternoon and really like what it has done to my O II. 
Can't see anything left to do but one nagging issue.

When switching modes, say from SSB to CW, the radio remembers the 
bandwidth from the last time it was set there. However, if the hi or low 
cuts were used in SSB mode, it get's carried over to CW. I would have 
preferred leaving the settings as they were left. This happens when 
using the band stacking feature. It's just a little annoying that could 
be lived with except for the overall perfection of everything else.

TenTec mailing list

<Prev in Thread] Current Thread [Next in Thread>
  • [TenTec] Orion II Firmware V3.026, Barry LaZar <=