Just on note on using the 9 mhz IF output on the rx366 with N4PY
software. I have not added any direct code for the rx366 9 mhz IF
output. But it should work fine if the rx366 tracks the main receiver.
In the N4PY program, right click the DUAL receive button. This will
turn on N4PY diversity mode and keep both receivers on the exact same
Carl Moreschi N4PY
121 Little Bell Dr.
Hays, NC 28635
On 2/4/2012 9:16 PM, Zivney, Terry wrote:
> My RX366 arrived via USPS this Saturday afternoon - installed it and it seems
> to work FB!
> I need info about which TMP jack on the RX366 board is the IF out for the
> panadapter -
> I plan on using the SPARE RCA jack on the back of my Orion 565 - I have a
> TMP cable
> ready to go - just need the ID of the jack on the RX366 board and confirm
> that the empty
> TMP jack on back panel is the connection to the SPARE RCA jack.
> I have my LP-PAN and N4PY and PowerSDR-IF software ready to go.
> Terry Zivney, N4TZ
> N4TZ at ARRL.NET
> TenTec mailing list
TenTec mailing list