[Top] [All Lists]

[TenTec] (no subject)

To: Discussion of Ten-Tec Equipment <tentec@contesting.com>
Subject: [TenTec] (no subject)
From: John Henry <jhenry@tentec.com>
Reply-to: Discussion of Ten-Tec Equipment <tentec@contesting.com>
Date: Sat, 4 Feb 2012 21:26:39 -0500
List-post: <tentec@contesting.com">mailto:tentec@contesting.com>
The 9MHz IF Output on the RX366 is the TMP connector on the TXRX board (The
board with the filters), right next to the F2 filter.
If you are going to use an LP-PAN, you should use the preamp offered by
We are modifying the user manual to point out it's location in a picture.
Should be available for download in a few days.

Good luck,

My RX366 arrived via USPS this Saturday afternoon - installed it and
it seems to work FB!
I need info about which TMP jack on the RX366 board is the IF out for
the panadapter -
I plan on using the SPARE  RCA jack on the back of my Orion 565 - I
have a TMP  cable
ready to go - just need the ID of the jack on the RX366 board and
confirm that the empty
TMP jack on back panel is the connection to the SPARE RCA jack.

I have my LP-PAN and N4PY and PowerSDR-IF software ready to go.

Terry Zivney, N4TZ
TenTec mailing list

<Prev in Thread] Current Thread [Next in Thread>