[Top] [All Lists]

[TenTec] RX366 panadpter interface

To: Discussion of Ten-Tec Equipment <tentec@contesting.com>
Subject: [TenTec] RX366 panadpter interface
From: John Henry <jhenry@tentec.com>
Reply-to: Discussion of Ten-Tec Equipment <tentec@contesting.com>
Date: Sat, 4 Feb 2012 21:28:02 -0500
List-post: <tentec@contesting.com">mailto:tentec@contesting.com>
Sorry, sent the message before I added the title... Now, it will appear in
the proper thread.

On Sat, Feb 4, 2012 at 9:26 PM, John Henry <jhenry@tentec.com> wrote:

> The 9MHz IF Output on the RX366 is the TMP connector on the TXRX board
> (The board with the filters), right next to the F2 filter.
> If you are going to use an LP-PAN, you should use the preamp offered by
> telepost.
> We are modifying the user manual to point out it's location in a picture.
> Should be available for download in a few days.
> Good luck,
> John
> ------------------------
> My RX366 arrived via USPS this Saturday afternoon - installed it and it seems 
> to work FB!
> I need info about which TMP jack on the RX366 board is the IF out for the 
> panadapter -
> I plan on using the SPARE  RCA jack on the back of my Orion 565 - I have a 
> TMP  cable
> ready to go - just need the ID of the jack on the RX366 board and confirm 
> that the empty
> TMP jack on back panel is the connection to the SPARE RCA jack.
> I have my LP-PAN and N4PY and PowerSDR-IF software ready to go.
> Terry Zivney, N4TZ
TenTec mailing list

<Prev in Thread] Current Thread [Next in Thread>