[Top] [All Lists]

Re: [TenTec] OII SWR Indication Off on 10 m

To: tentec@contesting.com
Subject: Re: [TenTec] OII SWR Indication Off on 10 m
From: Rsoifer@aol.com
Reply-to: Discussion of Ten-Tec Equipment <tentec@contesting.com>
Date: Mon, 6 Feb 2012 12:59:32 -0500 (EST)
List-post: <tentec@contesting.com">mailto:tentec@contesting.com>
Actually, the O II SWR sensor was never that accurate anyway, compared to a 
good external wattmeter.  The O II SWR reading is also dependent on the 
power level, i.e., it reads higher at full output than in the Tune position.  
This is not a V3 problem; it's always been there.

73 Ray W2RS

In a message dated 2/6/2012 5:53:03 PM GMT Standard Time, glhuber@msn.com 

> Reply-to:tentec@contesting.com
> To:tentec@contesting.com
> Sent from the Internet 
TenTec mailing list

<Prev in Thread] Current Thread [Next in Thread>