[Top] [All Lists]

[TenTec] OMNI D ser B low power output--still no joy

To: tentec@contesting.com
Subject: [TenTec] OMNI D ser B low power output--still no joy
From: scottsheppard@videotron.ca
Reply-to: Discussion of Ten-Tec Equipment <tentec@contesting.com>
Date: Sat, 11 Feb 2012 16:01:23 -0500
List-post: <tentec@contesting.com">mailto:tentec@contesting.com>
well, I have replaced all diodes save the zenor, the small signal transistors 
have also been replaced with 2n3904's and I have bypassed the PA all 
together...have virtually no output---maybe something in teh QRPp 
range...hardly moves needle at all on the SWR (Fwd) pos...

I do note my 'T' voltage is only 9.4 as opposed to 10.4...my meter may be off a 
bit but thats over a volt...can the T voltage be adjusted?

Sincerely appreciate all the input I have rec'd...

TenTec mailing list

<Prev in Thread] Current Thread [Next in Thread>