Scott, that T voltage is okay
do you have the tD voltage on low level driver? Should be about 4.5 volts or so
On Feb 11, 2012, at 4:01 PM, firstname.lastname@example.org wrote:
> well, I have replaced all diodes save the zenor, the small signal transistors
> have also been replaced with 2n3904's and I have bypassed the PA all
> together...have virtually no output---maybe something in teh QRPp
> range...hardly moves needle at all on the SWR (Fwd) pos...
> I do note my 'T' voltage is only 9.4 as opposed to 10.4...my meter may be off
> a bit but thats over a volt...can the T voltage be adjusted?
> Sincerely appreciate all the input I have rec'd...
> TenTec mailing list
TenTec mailing list