[Top] [All Lists]

[TenTec] OMNI D ser B low power output--still no joy

To: tentec@contesting.com
Subject: [TenTec] OMNI D ser B low power output--still no joy
From: scottsheppard@videotron.ca
Reply-to: Discussion of Ten-Tec Equipment <tentec@contesting.com>
Date: Sun, 12 Feb 2012 17:53:49 -0500
List-post: <tentec@contesting.com">mailto:tentec@contesting.com>
The power supply is a 32 amp switching supply...meter on the amp is pretty 
steady at 13.8 but note my digital meter is a bit off...perhaps by a half volt 
or so.

given that the LLD is now connected essentially to the output of the rig 
bypassing the PA completely, it would seem the LLD is not doing its thing..yet, 
I have replaced pretty much all I could and no change...unless its some stupid 
little resistor or something...

It would seem to me that if I was getting up to 2-4 watts out with the PA on 
and tweaked, it was doing something...but only serving to amplify what little 
it rec from the LLD (or previous stage)...the stage before the LLD is the TX 
mixer...what power level should be generated out of it?

Time to get trained up on the osc that hase been sitting around collecting dust!


TenTec mailing list

<Prev in Thread] Current Thread [Next in Thread>