The power supply is a 32 amp switching supply...meter on the amp is pretty
steady at 13.8 but note my digital meter is a bit off...perhaps by a half volt
given that the LLD is now connected essentially to the output of the rig
bypassing the PA completely, it would seem the LLD is not doing its thing..yet,
I have replaced pretty much all I could and no change...unless its some stupid
little resistor or something...
It would seem to me that if I was getting up to 2-4 watts out with the PA on
and tweaked, it was doing something...but only serving to amplify what little
it rec from the LLD (or previous stage)...the stage before the LLD is the TX
mixer...what power level should be generated out of it?
Time to get trained up on the osc that hase been sitting around collecting dust!
TenTec mailing list