[Top] [All Lists]

Re: [TenTec] OMNI C Mixer or PTO problem

To: Discussion of Ten-Tec Equipment <tentec@contesting.com>
Subject: Re: [TenTec] OMNI C Mixer or PTO problem
From: Michael Silevitch <msilevitch@coe.neu.edu>
Reply-to: Discussion of Ten-Tec Equipment <tentec@contesting.com>
Date: Mon, 20 Feb 2012 13:01:55 -0500
List-post: <tentec@contesting.com">mailto:tentec@contesting.com>
Dear Scott

R23 is the level adjust pot on the Oscillator-mixer board. I think that's
the one you are referring to. The manual only makes a passing reference to
it when describing setting the balance in the mixer. Is this the pot you
are referring to? Any other thoughts? The reason I ask is that the problem
arose as a result of shipping. It's not clear whether the pot would be
moved out of adjustment due to the vibration etc.

         Mike K1PEV

On 2/20/12 10:14 AM, "scottsheppard@videotron.ca"
<scottsheppard@videotron.ca> wrote:

>I think I may be able to help on  this having spent  a LOT of time inside
>the OMNI...adjust the thumbwheel POT on the mixer/vfo board--it will
>ensure you are sending enough signal to stay on freq and send it to your
>counter...I am not near teh radio but I think it was referred to as
>adjustment level or something...  let me know.  scott  VA3IED
>TenTec mailing list

TenTec mailing list

<Prev in Thread] Current Thread [Next in Thread>