[Top] [All Lists]

Re: [TenTec] OMNI C Mixer or PTO problem

To: Discussion of Ten-Tec Equipment <tentec@contesting.com>
Subject: Re: [TenTec] OMNI C Mixer or PTO problem
From: Michael Silevitch <msilevitch@coe.neu.edu>
Reply-to: Discussion of Ten-Tec Equipment <tentec@contesting.com>
Date: Mon, 20 Feb 2012 17:04:23 -0500
List-post: <tentec@contesting.com">mailto:tentec@contesting.com>
Dear Scott

I moved all three and there was no effect. (I hope I reset them more or
less to their original values!)

         Mike K1PEV


On 2/20/12 4:24 PM, "scottsheppard@videotron.ca"
<scottsheppard@videotron.ca> wrote:

>remember there are 3 pots there/// (maybe just 2 on the omni c) the one
>that actually turns in a direction parallel to the board should be it. i
>believe it is actually called the mixer balance...are you getting any
>signal at all on the rig regardless of display freq?
>TenTec mailing list

TenTec mailing list

<Prev in Thread] Current Thread [Next in Thread>