[Top] [All Lists]

Re: [TenTec] Omni C mixer PTO problem

To: Discussion of Ten-Tec Equipment <tentec@contesting.com>
Subject: Re: [TenTec] Omni C mixer PTO problem
From: Michael Silevitch <msilevitch@coe.neu.edu>
Reply-to: Discussion of Ten-Tec Equipment <tentec@contesting.com>
Date: Mon, 20 Feb 2012 18:53:16 -0500
List-post: <tentec@contesting.com">mailto:tentec@contesting.com>
Dear Scott

I will bring home some test equipment from the university where I teach.
That should help give me some valuable info. I'll keep plugging!

I owned a Triton IV for 30+ years and am now "upgrading" to the Corsair
and Omni C series. I do like the engineering that went into these Ten Tec

         Mike K1PEV

On 2/20/12 6:25 PM, "scottsheppard@videotron.ca"
<scottsheppard@videotron.ca> wrote:

>you are correct Steve...it's why you can actually receive dual signals
>simultaneously when using the 243 external vfo...pretty cool actually...
>As for Mikes problem, I am unclear as to whether or not he is getting any
>rec'd signal at all...??
>Mike: can you confirm this? Are you getting any signals rec'd?? Don't
>worry about the POTs..they are an easy adjust...
>Also check your R value voltages...start with the RF amp (its the little
>elevator contraption that goes up and down ...the R voltage is about 12.5
>volts and is the white wire with blues stripe...the only thing is even
>with out signals you would get a correct freq display...
>also make sure the red wire near the rear of osc mixer board indicates
>your supply voltage...if yo udont have any power there you wont have any
>sig or correct  freq display...these rigs do not travel well and there
>are lots of things to come loose...the good news is there are a LOT of
>smart folks on here (myself not beng one of them) that will help you find
>the issue. Most people are honest and i am sure the problem is small and
>it worked with the other owner...this series of OMNI are amazing... I
>have owned a C, two A's and now a D....
>TenTec mailing list

TenTec mailing list

<Prev in Thread] Current Thread [Next in Thread>