[Top] [All Lists]

Re: [TenTec] no ALC

To: tentec@contesting.com
Subject: Re: [TenTec] no ALC
From: John Molenda <cdistflatfoot@gmail.com>
Reply-to: Discussion of Ten-Tec Equipment <tentec@contesting.com>
Date: Thu, 23 Feb 2012 16:46:13 -0500
List-post: <tentec@contesting.com">mailto:tentec@contesting.com>
On 2/23/2012 4:42 PM, Mike Bryce wrote:
> John,
> As goofy as it sounds, the ALC can be affected by the SWR of the antenna. Try 
> using a dummy load and see if the ALC blinks with voice peaks.
> It's not at all uncommon for a ten tec rig to go into over current protection 
> and never light the ALC indicator.
> Mike wb8vge
> Sent from my iPhone
> On Feb 23, 2012, at 3:16 PM, John Molenda<cdistflatfoot@gmail.com>  wrote:
>> Hello all , new Eagle here .  I followed directions to get on SSB and I
>> can not get the alc light to flicker on voice peaks even with the mic
>> gain turned up all the way .  am using supplied TT hand mic .  John kb2huk
>> BTW   the rx is so nice and quiet , great rig .
>> _______________________________________________
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tente

I found out it was the hand mic and I ordered a new one .  thank you 
John kb2huk
TenTec mailing list

<Prev in Thread] Current Thread [Next in Thread>