Here we go again...
After my trials and tribulations of the previous posts and getting the OMNI D
to transmit as per specs, I was luck to find a fellow on teh reflector here
that had an extra band pass filter board i could use that included the 30m
Bandpass filter and some other warc bands...30m is my favorite band...I tried
to get at least the instructions but Ten-Tec no longer has them unfortunately...
So, I replaced the complete board assembly and wired it up...rx is no problem
but I have no tx output at all. Rig keys OK but nothing for output...pretty
sure the problem revolves around the BP filters. Before I go into the full
blown trouble shooting mode (again), does anyone happen to have a copy of the
instructions for the old kit upgrade?
TenTec mailing list