[Top] [All Lists]

[TenTec] no TX after Bandpass filter kit 'upgrade' Omni D

To: tentec@contesting.com
Subject: [TenTec] no TX after Bandpass filter kit 'upgrade' Omni D
From: Scott Sheppard <scottsheppard@videotron.ca>
Reply-to: Discussion of Ten-Tec Equipment <tentec@contesting.com>
Date: Sun, 11 Mar 2012 09:46:45 -0400
List-post: <tentec@contesting.com">mailto:tentec@contesting.com>
Here we go again...

After my trials and tribulations of the previous posts and getting the OMNI D 
to transmit as per specs, I was luck to find a fellow on teh reflector here 
that had an extra band pass filter board i could use that included the 30m 
Bandpass filter and some other warc bands...30m is my favorite band...I tried 
to get at least the instructions but Ten-Tec no longer has them unfortunately...

So, I replaced the complete board assembly and wired it up...rx is no problem 
but I have no tx output at all. Rig keys OK but nothing for output...pretty 
sure the problem revolves around the BP filters. Before I go into the full 
blown trouble shooting mode (again), does anyone happen to have a copy of the 
instructions for the old kit upgrade?


scott  VA3IED
TenTec mailing list

<Prev in Thread] Current Thread [Next in Thread>