[Top] [All Lists]

[TenTec] Corsair II RF Gain Problem

To: TenTec@contesting.com
Subject: [TenTec] Corsair II RF Gain Problem
From: Russ Straate <rstraate@gmail.com>
Reply-to: Discussion of Ten-Tec Equipment <tentec@contesting.com>
Date: Wed, 21 Mar 2012 19:46:47 -0500
List-post: <tentec@contesting.com">mailto:tentec@contesting.com>
Group.  Thanks for the feedback on the RF Gain.  It appears I have a
problem with my rig.  The RF gain only operates over a very narrow range
when rotating the control.  At about the 6 marking on the dial, the signal
disappears.  The receiver appears to be fine with when wide open so it does
not appear that the receiver level is low.  I have checked the pot with the
wires disconnected an it shows the 10K ohm range as it should.  Any
thoughts on where else I should look?
TenTec mailing list

<Prev in Thread] Current Thread [Next in Thread>