I don't think that indicates a problem.
I have two CorsairIIs - one of them "turns off" at 7.5 on the RF Gain,
and the other one at 4.
On 22/03/2012 00:46, Russ Straate wrote:
> Group. Thanks for the feedback on the RF Gain. It appears I have a
> problem with my rig. The RF gain only operates over a very narrow range
> when rotating the control. At about the 6 marking on the dial, the signal
> disappears. The receiver appears to be fine with when wide open so it does
> not appear that the receiver level is low. I have checked the pot with the
> wires disconnected an it shows the 10K ohm range as it should. Any
> thoughts on where else I should look?
> TenTec mailing list
TenTec mailing list