[Top] [All Lists]

[TenTec] P3 and ORION II ?

To: tentec@contesting.com
Subject: [TenTec] P3 and ORION II ?
From: David Perrin <dbperrin@gmail.com>
Reply-to: Discussion of Ten-Tec Equipment <tentec@contesting.com>
Date: Tue, 27 Mar 2012 20:48:52 -0400
List-post: <tentec@contesting.com">mailto:tentec@contesting.com>
 It's not working.
  I assembled the Clifton Labs. buffer amplifier to use with the ORION II and 
Elecraft P3.  It is installed in an outboard shielded container and connected 
to and have confirmed that an input into the buffer amp at approximately 9MHz, 
from a signal generator is also at the output of the buffer amp at roughly the 
same amplitude. (No scope, just a receiver and a Voltmeter). 
 I chose to connect to the ORION II using a length of mini coax across the 
resistor suggested by VE7TK fro his web page article:

TenTec mailing list

<Prev in Thread] Current Thread [Next in Thread>
  • [TenTec] P3 and ORION II ?, David Perrin <=