[TenTec] Calibrator hookup for 515?

[Al Gulseth <wb5jnc@centurytel.net>]

Greetings,

I'm in need of a schematic/info on the 206A (or simply, how/where to feed a 
calibrator into the 515, and at what level.) The only possibility I've come 
up with so far is on the "defeat" (pin 3) of the Molex connector, which goes 
to gate 2 of Q1 on the 80262 front end board. Is this correct, or does it tie 
in somewhere else? (I had thought of using a small whip antenna but that's 
obviously not the way the 206A was connected!)

TNX/73, Al
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec