TenTec
[Top] [All Lists]

Re: [TenTec] TT Model 1225 SWR/Watt meter question

To: Discussion of Ten-Tec Equipment <tentec@contesting.com>
Subject: Re: [TenTec] TT Model 1225 SWR/Watt meter question
From: James Boswell <ka5siw@yahoo.com>
Reply-to: James Boswell <ka5siw@yahoo.com>, Discussion of Ten-Tec Equipment <tentec@contesting.com>
Date: Sat, 1 Dec 2012 09:27:13 -0800 (PST)
List-post: <tentec@contesting.com">mailto:tentec@contesting.com>
James,
     Did you remove the paint from the contact surface of the chassis and coax 
connectors (SO239)?
 
      Also check for excess flux on a solder joint or a cold solder joint.
 
      I hope that helps, Take Care,  73'S    KA5SIW
 

________________________________
 From: Richards <jruing@ameritech.net>
To: Discussion of Ten-Tec Equipment <tentec@contesting.com> 
Sent: Friday, November 30, 2012 1:41 PM
Subject: [TenTec] TT Model 1225 SWR/Watt meter question
  
Greetings -

I recently built a Model 1225 SWR/Watt meter kit.   At first, it was easy to 
align it, and it worked as expected.

Now, maybe a month or so later, I cannot get the SWR  (return power) meter to 
behave as expected.  I have several other meters, by Ten-Tec, Palstar, Daiwa 
and on my Omni VII,  all of which agree with each other, but the SWR (return 
power) mater runs high no matter how carefully I set it.  Now it always too 
high (the forward power meter seems to act as it should, and within 
expectations, even considering the rather wide tolerance these things have.

Any ideas?   Any special tricks or techniques to help set it so it measures up 
like my other meters?     It seemed OK at first...

Losing my mind...  Thank you.

------------------- James -K8JHR  -------------------------
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec

<Prev in Thread] Current Thread [Next in Thread>