Set Mark High.
73, Dan W4UH
-----Original Message-----
From: TenTec [mailto:tentec-bounces@contesting.com] On Behalf Of k2ep
Sent: Sunday, December 09, 2012 8:36 PM
To: Discussion of Ten-Tec Equipment
Subject: [TenTec] Help with FSK with an Orion II
I am trying to use my O2 on fsk. Unfortunately the manual gives very little
info. on this mode. When receiving in fsk mode I must adjust my pbt to
about -1800 to get readable signal. It decodes fine then. Is this normal?
Is there some where I can get more info. on operating fsk? The keying sound
ok on the monitor. Mark is set low. Are their any other setting I need to
check? I'm using a Rigblaster Advantage and mmtty s/w. Any help would be
appreciated.
Tnx, Ernie K2EP
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|