TenTec
[Top] [All Lists]

Re: [TenTec] Corsair 560 alignment

To: Discussion of Ten-Tec Equipment <tentec@contesting.com>
Subject: Re: [TenTec] Corsair 560 alignment
From: Barry N1EU <barry.n1eu@gmail.com>
Reply-to: Discussion of Ten-Tec Equipment <tentec@contesting.com>
Date: Thu, 3 Oct 2013 17:51:16 +0000
List-post: <tentec@contesting.com">mailto:tentec@contesting.com>
Congrats - the Corsair is a fine rig.  The Corsair should have
excellent sensitivity on all bands.  You might need to do a little
contact cleaning on internal connectors, xtal filters, switches,
controls, etc. as well as aligning per Section III of the manual.
Look closely for poor solder connections on PCBs.  PCBs are generally
easy to remove if you need to - remove a few screws and the numerous
well marked cable connectors and they pop right out.

Narrow filters for the 6.3MHz i.f. are often available from the usual
used ham gear outlets and on this reflector.

73/GL,
Barry N1EU

On Thu, Oct 3, 2013 at 5:00 PM, Spencer <k5gak@powerc.net> wrote:
> I have a Corsair that was given to me. The rcvr sensitivity seems blah, some
> sigs on 20 and 30 meters, thats it
> Puts out full power. I plan to check things starting at the speaker working
> to the antenna. Are there any GOTGHA's I should look out
> for?
> I will use the rig for CW and maybe PSK in the future.
> Are there any of the narrow filters available other than new?
>
> Spencer
> W1GAK
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec

<Prev in Thread] Current Thread [Next in Thread>