Steve,
get +5 to it
then use you scope on the “A” output.
with each turn, you should see a square wave as the encoder sends out a
quadrature pulse. This pulse will be 90 deg out of phase with the “B” output.
that way the logic knows what way the encoder is turning
you should see both quadrature pulses as you turn the knob, if you use both
channels of your scope.
Not sure, but if the pulses look a bit fuzzy, you might need a 10K pull up on
the output to square ‘em up
But I’d try another speaker first
Mike, WB8VGE
SunLight Energy Systems
The Heathkit Shop
http://www.theheathkitshop.com/
J e e p
o|||||||o
A man with one clock knows what time it is. A man with two clocks is never
sure.
On Nov 8, 2013, at 10:32 AM, Steve Garwood <n0czv@frontier.com> wrote:
> Carl,
>
> I had read that in archives, but I have not found any original
> documentation. The connectors are wired differently - my first fail point
> was not having 5 VDC on the encoder. My assumption is that the Paragon II
> will need lines added to support the 301. Searching for additional
> information now.....
>
> Steve, N0CZV
> Attica, Ohio
> n0czv@frontier.com
>
>
> -----Original Message-----
> From: TenTec [mailto:tentec-bounces@contesting.com] On Behalf Of Carl
> Moreschi
> Sent: Friday, November 08, 2013 7:41 AM
> To: Discussion of Ten-Tec Equipment
> Subject: Re: [TenTec] Paragon II and 301 Remote
>
> Yes the 301 knob will work with the Paragon II.
>
> Carl Moreschi N4PY
> 58 Hogwood Rd
> Louisburg, NC 27549
> www.n4py.com
>
>
>
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|