TenTec
[Top] [All Lists]

Re: [TenTec] Orion 565 tuning encoder

To: Discussion of Ten-Tec Equipment <tentec@contesting.com>
Subject: Re: [TenTec] Orion 565 tuning encoder
From: Barry N1EU <barry.n1eu@gmail.com>
Reply-to: Discussion of Ten-Tec Equipment <tentec@contesting.com>
Date: Sat, 21 Jun 2014 15:36:17 +0000
List-post: <tentec@contesting.com">mailto:tentec@contesting.com>
Thanks Sinisa.  vfoB would not tune at all.  I removed the encoder and
connected it to the cable going to the vfoA encoder and the encoder now is
fully functional.  There is a problem somewhere upstream of the connector
going to the vfoB encoder.

I need to figure out the signal routing and check upstream connections etc.

73, Barry N1EU





On Sat, Jun 21, 2014 at 2:41 PM, shristov <shristov@ptt.rs> wrote:

>
> Barry N1EU <barry.n1eu@gmail.com> wrote:
>
> > Does anyone know the specs of the main VFO tuning encoder in the Orion or
> > can recommend a source for a replacement?
>
>
> It's OAK GRIGSBY part number 94Q 125-02-00606
>
>
> 73,
>
> Sinisa  YT1NT, VE3EA
>
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec

<Prev in Thread] Current Thread [Next in Thread>