TenTec
[Top] [All Lists]

[TenTec] Omni 6 Plus intermittent no TX or RX on 10 meters

To: "Discussion of Ten-Tec Equipment" <tentec@contesting.com>
Subject: [TenTec] Omni 6 Plus intermittent no TX or RX on 10 meters
From: "Mark Kenward" <k8vf_mark@centurytel.net>
Reply-to: Mark Kenward <k8vf_mark@centurytel.net>, Discussion of Ten-Tec Equipment <tentec@contesting.com>
Date: Thu, 25 Jun 2015 21:52:00 -0400
List-post: <tentec@contesting.com">mailto:tentec@contesting.com>

Take a 4x6 inch card and start at the back, holding card vertically, only 
exposing 1/4 of the board at a time...as you go across, put the dryer to it, 
and if it comes on-or goes off, remove heat and do same from left to right 
after it comes back on (or off) again. I also had a fan to cool it as mine 
would only work when hot.
 Just a suggestion, but I did it and found a one inch area which was where the 
problem was.


I sent it to Dollywood 3 times and they could NOT duplicate the issue......?  
It ALWAYS was off till the rig was on an hour or more......Their service area 
must be 100 degrees or more.  3 times...new box each time, and I am sure that 
they never opened the box the 3rd time.  I was really ticked, and I fixed it in 
5-10 minutes once I tried to do it.......shameful.

Best of wishes.

Mark
K8VF
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec

<Prev in Thread] Current Thread [Next in Thread>