[Top] [All Lists]

[TenTec] RM-500 Rack Mount for Omni and Paragon?

To: Discussion of Ten-Tec Equipment <tentec@contesting.com>
Subject: [TenTec] RM-500 Rack Mount for Omni and Paragon?
From: Steve Garwood <n0czv@frontier.com>
Reply-to: Discussion of Ten-Tec Equipment <tentec@contesting.com>
Date: Sun, 9 Aug 2015 19:34:31 -0400
List-post: <tentec@contesting.com">mailto:tentec@contesting.com>
I have a RM-500 Rack Mount set of rails and handles and a question.

Between the RM-500 and a Paragon II and an Omni VI Plus, I am not seeing any 
holes that line up that match the radios and the panels.  There is a 
rectangular cutout on the sides of the panels.  There are two holes near the 
front, two at the rear, and two near the bottom edge.  The radio has four 
screws on each side.

Am I missing something here?  It doesn't seem right the there should be any 
drilling anywhere.

I have found pictures online of the rack mount kit, but none of one installed 
on a radio.

Anyone running rack mounts that can shed some light on the installation?


Steve, N0CZV
TenTec mailing list

<Prev in Thread] Current Thread [Next in Thread>