Ken, that cable is easy to build. You will need a db25 to fit the radio and
then two more to mate with
your connectors. You will only need a 3 wire shielded cable and use pins
1,2,3, and the shield to pin 7.There is a lot of info on the net about RS232
cables and if you use the db9 (newer), the wiring is a bitdifferent. The
diagram in the Omni VI manual is wrong, need to swap pins 2&3 on one end.
Clayton N4EV
From: Ken <kakoval@cox.net>
To: tentec@contesting.com
Sent: Friday, August 5, 2016 12:12 PM
Subject: [TenTec] 236 Cable
I would like to connect my Omni 6+ and Hercules II, together under
computer control. In order to do this, I need a 236 "Y" cable , the one
with three connectors. Does anyone have one of these cables they would
be willing to part with? If not, does anyone have a wiring diagram?
Thanks... Ken, K9PGC
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|