TenTec
[Top] [All Lists]

Re: [TenTec] New Discussion Orion III Survey question

To: "'Mike Dishop'" <n8wff@yahoo.com>, "'Discussion of Ten-Tec Equipment'" <tentec@contesting.com>
Subject: Re: [TenTec] New Discussion Orion III Survey question
From: "Stan" <w4ag@mindspring.com>
Reply-to: Discussion of Ten-Tec Equipment <tentec@contesting.com>
Date: Wed, 22 Feb 2017 13:08:03 -0500
List-post: <tentec@contesting.com">mailto:tentec@contesting.com>
Yes, the same front would be fine for an O3. Keep up the great work you are 
doing.

73,
Stan, W4AG (owner of an Orion and an Orion II)


-----Original Message-----
From: TenTec [mailto:tentec-bounces@contesting.com] On Behalf Of Mike Dishop 
via TenTec
Sent: Tuesday, February 21, 2017 3:36 AM
To: Discussion of Ten-Tec Equipment <tentec@contesting.com>
Cc: Mike Dishop <n8wff@yahoo.com>
Subject: [TenTec] New Discussion Orion III Survey question

 Without any distraction or off topic replies, I want to know if the Orion III 
can use the same front panel with the same controls and features /  buttons/ 
knobs and user interface.
The screen will be different, the guts will be different, the box may be 
different, and all of this does not matter.
All I want to know is if I can use the same expensive injection mold for the 
front.  If the answer is no then we will have to use a painted front like 
certain other people use.
This is not telegraphing that an O3 is eminent, under development or any other 
speculation.  Is the O2 front panel OK or not OK. that is all I want to know.
73 DE N8WFF
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec

_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec

<Prev in Thread] Current Thread [Next in Thread>