TenTec
[Top] [All Lists]

Re: [TenTec] [] Running a Century 21 on external 12V power

To: Discussion of Ten-Tec Equipment <tentec@contesting.com>
Subject: Re: [TenTec] [] Running a Century 21 on external 12V power
From: Byron Cordes <byroncordes@icloud.com>
Reply-to: Discussion of Ten-Tec Equipment <tentec@contesting.com>
Date: Mon, 05 Jun 2017 16:02:18 -0500
List-post: <mailto:tentec@contesting.com>
Try grounding ground side of speaker to ground from power supply.
If hum is still there there is a 4.7 ohm resistor that might be shorted 
Or a 270 uf cap open  both feed the audio amp 

Byron Cordes

> On Jun 5, 2017, at 3:42 PM, Josh Gibbs <gibbsjj@gmail.com> wrote:
> 
> Hi Chris,
> 
> The hum is present in the speaker, just not so noticeable because it is
> much less sensitive and much further from my ear. I suspect the speaker is
> less responsive to frequencies below 120Hz than my headphones, which helps.
> 
> I have tried other headphones. I have also listened to the audio directly
> at the output of the audio amp board. Even when I short the input to the
> audio board to ground, I can still hear the hum. Even when I powered the
> pre-amp and audio amp boards via external 12VDC the hum remained. I'm
> pretty confident the hum is magnetically coupled. The only time I don't
> hear the hum is when I power the radio entirely from external 12 VDC.
> 
> Is this normal for this rig, or is there a problem? That is what I'm now
> attempting to determine!
> 
> The radio works great otherwise, and I likely would never have noticed
> anything if I hadn't plugged in my headphones =)
> 
> I've learned a lot while working on this radio, which was one of my goals
> in buying it. Big thanks to the the awesome amount of knowledge of the
> Ten-Tec list, and willingness to share it!
> 
> 73,
> 
> -Josh WA7FPV
> 
>> On Mon, Jun 5, 2017 at 12:29 PM, Chris Howard w0ep <w0ep@w0ep.us> wrote:
>> 
>> 
>> 
>> 
>> I'm not an electronics whiz.  But to me, if you're getting
>> the noise in headphones but not in the speaker, it sounds
>> like the headphone cord is picking it up.
>> 
>> If you have cracked capacitors in the power supply,
>> I wonder if you've got a 120 Hz spark gap going there.
>> The headphone cord is acting as an antenna and picking it up.
>> 
>> How to test that theory, turn down the audio on the Century 21.
>> Use the same headphones on some other piece of electronic
>> equipment in close proximity to the C-21 and see if you get the noise.
>> 
>> 
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec

<Prev in Thread] Current Thread [Next in Thread>