TenTec
[Top] [All Lists]

Re: [TenTec] Tentec 585 PLL

To: <tentec@contesting.com>
Subject: Re: [TenTec] Tentec 585 PLL
From: Vic Klein via TenTec <tentec@contesting.com>
Reply-to: Discussion of Ten-Tec Equipment <tentec@contesting.com>
Date: Wed, 6 Sep 2017 06:06:02 -0400
List-post: <mailto:tentec@contesting.com>
Solder problems on the Major and Minor Loop boards are probably the most
common problem with Paragons, which can result in a problem with the PLL. If
the problem is on every band then it is probably the minor loop board, if it
is confined to a couple of bands then it probably is the major loop board.
The problem is most likely caused by bad solder connections. Often you can
get a quick fix by just reheating the connections on the RF circuit area of
the board indicated in the problem, but my experience is that this will be a
temporary fix. The best is to remove the offending solder using a
solder-sucker or similar and resolder those connections with fresh material.
Since doing that I have gone years without an issue with the PLL failing to
lock or becoming unstable.

 

The boards are pretty easy to access and remove. One has a shield soldered
on the entire bottom, but even that is not too bad to deal with. Be sure you
have the complete owner's manual, which also includes detailed service
information, circuit diagrams, and pictures for each of the boards.

 

=Vic=

WA4THR

 

----------------------------------------------------------------------------
---------------------

 


To: 

"Tentec@Contesting.com <mailto:Tentec%40Contesting.com> "
<Tentec@Contesting.com <mailto:Tentec%40Contesting.com> >


Subject: 

[TenTec] Tentec 585.


From: 

Robin Lentz <robinlentz1@hotmail.com <mailto:robinlentz1%40hotmail.com> >


Reply-to: 

Discussion of Ten-Tec Equipment <tentec@contesting.com
<mailto:tentec%40contesting.com> >


Date: 

Tue, 5 Sep 2017 13:57:50 +0000


List-post: 

<mailto:tentec@contesting.com>


Good morning.  I have a Tentec 585 which I have enjoyed using for years.  In


recent times it has developed a problem with the phase lock loop not wanting
to 

lock.  At first I could leave the rig on for a few minutes and pll would
lock.  

Now I can run the rig all day and pll will not lock most of the time.  Any 

suggestions on how to cure this problem?  Thanks and 73 de WA4NLF

                                

 

_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec

<Prev in Thread] Current Thread [Next in Thread>