TenTec
[Top] [All Lists]

Re: [TenTec] Orion II Display problem?

To: Discussion of Ten-Tec Equipment <tentec@contesting.com>
Subject: Re: [TenTec] Orion II Display problem?
From: Rod Greene via TenTec <tentec@contesting.com>
Reply-to: Discussion of Ten-Tec Equipment <tentec@contesting.com>
Date: Mon, 6 Nov 2017 22:24:22 +0000 (UTC)
List-post: <mailto:tentec@contesting.com>
Thanks Gary. I did replace the snaphat battery last year too. If the problem 
crops up again, I will try the hard reset.73, Rod/w7zrc
 

    On Monday, November 6, 2017, 3:20:11 PM MST, Dukes HiFi 
<dukeshifi@comcast.net> wrote:  
 
 Did you change your CPU battery?

Try that, then a hard reset.

See what transpires.

Gary


> On Nov 6, 2017, at 4:07 PM, Rod Greene via TenTec <tentec@contesting.com> 
> wrote:
> 
> During SSCW I noticed (after a few hours of operating) the number 9 creeping 
> in from the right side of the display. It never completely became visible, 
> but was definitely there and in large font. Later on in the SS a third 
> megahertz number appeared on top of the regular megahertz numbers for each 
> VFO. I could correct this easily by turning the OII off and back on. I was 
> using N1MM+ in SO2V mode. 
> Any thots on this or other similar experience? I have replaced the A9 board 
> caps last year. And the display is working fine today.
> Thanks and 73, Rod/w7zrc
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec

_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
  
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec

<Prev in Thread] Current Thread [Next in Thread>