Thanks Carl!
Sent from AOL Mobile Mail
-----Original Message-----
From: Carl Moreschi <n4py3@earthlink.net>
To: Discussion of Ten-Tec Equipment <tentec@contesting.com>
Sent: Fri, Mar 2, 2018 04:21 PM
Subject: Re: [TenTec] Winlink and Winmoor on an Omni 6 Plus
It uses the Icom interface. Just select an Icom radio at the correct
baud rate.
Carl Moreschi N4PY
58 Hogwood Rd
Louisburg, NC 27549
<a href="http://www.n4py.com"; target="_blank">www.n4py.com</a>
On 3/2/2018 4:07 PM, Joe Papworth via TenTec wrote:
> Gents,
> Winmoor does not support the Omni 6 Plus in their Rig Control software.
> I'm thinking that someone once told me there was a different brand and model
> that used a command set equal to or very similar to the Omni 6.
> Does that ring any bells?
>
> Or, has anyone found another work-around for this problem?
>
> Thanks, Joe, K8MP
>
>
>
> _______________________________________________
> TenTec mailing list
> <a href="mailto:TenTec@contesting.com";>TenTec@contesting.com</a>
> <a href="http://lists.contesting.com/mailman/listinfo/tentec";
> target="_blank">http://lists.contesting.com/mailman/listinfo/tentec</a>
_______________________________________________
TenTec mailing list
<a href="mailto:TenTec@contesting.com";>TenTec@contesting.com</a>
<a href="http://lists.contesting.com/mailman/listinfo/tentec";
target="_blank">http://lists.contesting.com/mailman/listinfo/tentec</a>
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|