Thanks, Mike. I have that calibration procedure, but the S meter is way high
and I need to put it back to zero when there is no signal present (short out
the ant input). I should have been more explicit in my cry for help.
73,
Troy, W6HV
-----Original Message-----
From: Mike Pagel
Sent: Tuesday, April 24, 2018 4:12 PM
To: 'Discussion of Ten-Tec Equipment'
Subject: Re: [TenTec] zero adjust S meter in Orion II
http://www.tentec.com/wp-content/uploads/2016/05/S-Meter_565_566_Calibration_Procedure.pdf
73, de Mike, K9UW
Amherst, WI
-----Original Message-----
From: TenTec <tentec-bounces@contesting.com> On Behalf Of Troy, W6HV
Sent: Tuesday, April 24, 2018 5:44 PM
To: tentec@contesting.com
Subject: [TenTec] zero adjust S meter in Orion II
I can't recall (or find) the way to zero the S meter in my Orion II. I have
the procedure for calibration. Any help?
Thanks,
Troy, W6HV
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|