Perform the BFO alignment in the sequence defined in the manual. All steps must
be done regardless of the mode you operate or do not operate. Be sure the radio
is up to operating temp. Perform the sequence 2 or 3 times as there is
interaction between the adjustments.
The set the Master Osc so the radio displays the correct frequency. The
display is not a true frequency measurement but is a display based on the
Master Osc. It does not know if the band Oscillator is off frequency. Also you
can trim each band to get the frequency per band a bit closer.
Bob, K4TAX
Sent from my iPhone
> On Nov 6, 2018, at 9:04 AM, Sven Ladegast via TenTec <tentec@contesting.com>
> wrote:
>
> Hello folks,
>
> I do have trouble aligning the TX carrier frequency on an Omni 6+.
>
> With no modulation applied, the TX carrier frequency shall be 9.00300 MHz
> measured at connector 73 of the board. I used a TMP-BNC cable and connected
> it to connector 73 and connected the BNC connector to my accurate frequency
> counter using a T-connector and additional 50 Ohms termination.
>
> The TX carrier frequency is aligned by turning the core of L2 but with the
> core complete turned out of the coil I get a maximum frequency of 8.9965 MHz
> and cannot get to 9.00300 MHz. Do have anyone an idea what is going wrong?
> Aged XTAL?
>
> 73!
>
> Sven, DJ2AT
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|