| To: | Discussion of Ten-Tec Equipment <tentec@contesting.com> |
|---|---|
| Subject: | Re: [TenTec] 405 amp |
| From: | MadScientist <dukeshifi@comcast.net> |
| Date: | Wed, 20 Feb 2019 21:56:20 -0600 |
| List-post: | <mailto:tentec@contesting.com> |
Can you send scan of schematic? Gary > On Feb 20, 2019, at 8:58 PM, Dan Presley <n7cqr@arrl.net> wrote: > > Anyone have any experience in servicing this little 50W amp? I picked it up > with a nice 509 but the RF sensing changeover has stopped working. I have a > maul (not service) with a schematic but any advice appreciated. Thanks. > Dan Presley N7CQR > n7cqr@arrl.net > > > _______________________________________________ > TenTec mailing list > TenTec@contesting.com > http://lists.contesting.com/mailman/listinfo/tentec |
| <Prev in Thread] | Current Thread | [Next in Thread> |
|---|---|---|
| ||
| Previous by Date: | [TenTec] 405 amp, Dan Presley |
|---|---|
| Next by Date: | Re: [TenTec] Coil values (bandpass section) on VI+ XO/LO board, MadScientist |
| Previous by Thread: | [TenTec] 405 amp, Dan Presley |
| Next by Thread: | Re: [TenTec] 405 amp, Rick |
| Indexes: | [Date] [Thread] [Top] [All Lists] |