TenTec
[Top] [All Lists]

Re: [TenTec] Omni-VI+, No Xmit on 15m & 17m

To: "'Discussion of Ten-Tec Equipment'" <tentec@contesting.com>
Subject: Re: [TenTec] Omni-VI+, No Xmit on 15m & 17m
From: "Jim C" <1291jim@gmail.com>
Reply-to: mail@eCrites.com, Discussion of Ten-Tec Equipment <tentec@contesting.com>
Date: Sat, 27 Apr 2019 10:47:54 -0700
List-post: <mailto:tentec@contesting.com>
Current consumption is high, even at low settings.

 

As I increase the power, it jumps from 5 amps to 20 as the power dial reaches 
about the 40% position (1100 or 1200).

 

Then if I increase power past that, the safety in the Ten Tec power supply 
kicks in and turns everything off.

 

Again, this only happens on 15 and 17 meters.

 

Jim 

W6JIM

 

From: Carlos <carlos.peco@gmail.com> 
Sent: Friday, April 26, 2019 9:45 PM
To: mail@ecrites.com; Discussion of Ten-Tec Equipment <tentec@contesting.com>
Subject: Re: [TenTec] Omni-VI+, No Xmit on 15m & 17m

 

Hi Jim,

Does the current consumption go up as you turn the power knob to the right? I'm 
thinking of an issue in the LPF filter as Gary mentions.

73,
Carlos VK1EA


On Saturday, April 27, 2019, Jim C <1291jim@gmail.com 
<mailto:1291jim@gmail.com> > wrote:
> Here are the symptoms.  Thanks for your advice in advance!
>
>
>
> *       All is well except for 15 and 17
> *       On these bands, No transmit, but receive is fine
> *       No indication of power-out on rig meter or outboard watt-meter, CW &
> SSB.
> *       CW Tone sounds normal until I increase the power dial to the 3pm
> position, about 70%, then the tone starts to flutter es Chirp.  But still no
> power out.
>
>
>
> No other issues with the rig on all other bands.
>
>
>
> 73,
>
>
>
> Jim
>
> W6JIM
>
>
>
>
>
>
>
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com <mailto:TenTec@contesting.com> 
> http://lists.contesting.com/mailman/listinfo/tentec
> 

_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec

<Prev in Thread] Current Thread [Next in Thread>